|
||
|
|
I had a non-working "Moulinex inicio 10" iron for repair. It was tricky to take apart. First remove two security screws holding the rear cover. You will need a flat blade screwdriver with a notch in the end. |
|
|
|
Then pull knobs and remove three screws securing the white handle section. Then using fingernails and spudgers, unclip the white handle section. |
|
|
|
Finally, remove two screws at the rear to allow the metal base to drop free. The element measured 30 Ohms. The thermostat contacts measured open-circuit when closed. A common fault. |
|
|
|
I cut a 5 mm wide strip of 600 grit carborundom paper to clean the contacts. |
|
|
|
Here's a closer look at the thermostat. The contacts are below it. I reassembled the iron with ordinary Pozidriv screws, not security screws. It tested OK. |
|
|
Send this page address - CLICK HERE - to a friend ! |
||
